Chromoly cages, chop-top profiles, roof and door integration, and mounts that don't crack at the weld — designed around your machine and built in our fab bay.
The conviction on this one is non-negotiable: a roll cage is the piece of the machine your family is counting on, and it deserves better than bolt-together tube from an overseas catalog. Factory cages meet a standard; good custom cages exceed it. Bad custom cages — undersized tube, cold-lap welds, gussetless joints at load points — are worse than what came off, no matter how good the powder coat looks.
Our fab bay builds cages the disciplined way: correct tube spec for the job (mild DOM or 4130 chromoly, chosen honestly), proper notching and fit-up before a single tack, full-penetration welds by a fabricator who does this weekly, and gussets where the loads actually go. Chop-top profiles, integrated roofs, door and harness-bar integration, spare-tire and light-bar mounts — designed as part of the structure, not clamped on after.
Cage work usually rides along with a bigger vision, and that's where our custom build program takes over — cage, suspension, power, and wiring planned as one machine instead of four purchases.
Platform notes: the Teryx KRX chassis takes structure beautifully and is a favorite in the fab bay. RZR and X3 owners usually come in for chop-tops and integrated spare mounts. Fleet and ranch machines get the practical version — overhead protection and rack structure that works as hard as the machine.
Every cage build ends with the same honesty the shop runs on: harness geometry checked, sight lines verified, and the weight change fed back into the suspension setup — because forty pounds of tube up high is a spring-rate conversation, and pretending otherwise is how "upgraded" machines end up handling worse.
Honest answer: DOM mild steel is right for most recreational machines — strong, predictable, easier to repair in the field. 4130 chromoly saves weight at the same strength and is the pick for race builds and riders chasing every pound. We quote both and tell you which your build actually justifies.
A properly engineered and welded custom cage — yes, meaningfully. Larger or better tube, triangulation where factory structures compromise for cost, and gusseting at the joints that matter. A cheap bolt-together kit cage — often no. The build quality is the variable, which is why ours are fabricated and welded in-house.
Usually. We assess whether the structure took damage beyond the visible bends — kinked tubes and pulled mounting points matter more than scraped paint. Sectioning in new tube properly is routine work; if the damage compromises the whole structure we'll tell you, because patching a compromised cage isn't a service, it's a liability.
Design to delivery, most full cages run two to four weeks depending on complexity and finish (powder coat adds time). Mounts and reinforcement work turns around in days. You get the real timeline in writing before we start — fab work is scheduled, not squeezed in.
Yes — and we'd rather you let us. Harness geometry is part of cage design: bar height and angle relative to the seat determine whether the harness protects or injures. We build the harness bar into the structure and mount the belts to spec, and it's included in the cage conversation from day one.
Tell us the machine, the vision, and how it gets used. We'll design the structure, spec the tube honestly, and build it like our own families ride in it.
(713) 555-0182